Reply to thread

for the repair. if possible, i'd drill out a hole in each side, and put a metal rod through to give it extra strength. you could make the holes a bit big to give the rod some play... squish bondo/putty/goop/whatever into the holes, insert the rod, cover your surfaces with whatever adhesive you like, push it together and line the parts up.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top