Reply to thread

Message

At the moment, I can't provide any pictures. But it looks just like the helmet in wizardofflight's helmet blueprints topic. I'm thinking of going with bondo though. How easy is that to work with?

I took a chance a purchased a small can of bondo and tested it on one of my ear pieces. It was much easier to work with that I had expected and yielded nice results after sanding. The only problem I've found so far, are small depressions where I smoothed the bondo down while applying. I tried putting more coats on to fill in the depressions, but I can't get it to work. Is there something else that's easier to work with that could be used to fill these holes?

[QUOTE="Dustfinger, post: 95374, member: 1570"] At the moment, I can't provide any pictures. But it looks just like the helmet in wizardofflight's helmet blueprints topic. I'm thinking of going with bondo though. How easy is that to work with? I took a chance a purchased a small can of bondo and tested it on one of my ear pieces. It was much easier to work with that I had expected and yielded nice results after sanding. The only problem I've found so far, are small depressions where I smoothed the bondo down while applying. I tried putting more coats on to fill in the depressions, but I can't get it to work. Is there something else that's easier to work with that could be used to fill these holes? [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification