Reply to thread

Mine was actually molded REALLY thick, so even after sanding off the extra piece it was still about a half inch thick. I'm happy that Jordy made it so thick :D


I wish I had taken more progress photos doing the modifications, but as I said my camera is terrible and I just get frusterated trying to get a decent photo. Here are a few I took early in the process, before I finished cleaning it up. The lower raised part looks a lot thicker in these photos as a result of the blurriness, but I think I got it to match what I see on the original. It tapers really funny too, that was a pain to figure out!

[ATTACH]3446[/ATTACH]

[ATTACH]3445[/ATTACH][ATTACH]3448[/ATTACH]






[ATTACH=full]3447[/ATTACH]




[ATTACH=full]3449[/ATTACH]


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top