Reply to thread

Message

So removed all the old foam. Sprayed new. Much much better density. Carved outlines and depth. To get good depth contours, I screen grabbed frames from ESB where he's being loaded into Slave 1 and composited them in Photoshop. Ended up with a perfect side on view of the prop's contours. Carved folds and features very roughly. Covered in masking tape and now soaked with thinned down PVA.

Starting to take form

May paper mache or may put fabric on. But to be honest, it looks 90% there already in person. Will decide when the glue is dry.

[QUOTE="KrakFox, post: 485243, member: 7157"] So removed all the old foam. Sprayed new. Much much better density. Carved outlines and depth. To get good depth contours, I screen grabbed frames from ESB where he's being loaded into Slave 1 and composited them in Photoshop. Ended up with a perfect side on view of the prop's contours. Carved folds and features very roughly. Covered in masking tape and now soaked with thinned down PVA. Starting to take form May paper mache or may put fabric on. But to be honest, it looks 90% there already in person. Will decide when the glue is dry. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification