Reply to thread

Message

actually i made those myself from scratch out of the oransje PVC Pipes (just asked a local hardwarestoe if they had some leftovers). i first made the bracers then taped some sheets ov paper or cardboard on them to measure the length and add the shape i wanted. then i transfered that pattern on to the PVC pipes and cut them out. finally i heated up the PVC shapes and shaped them to fit the bracers (what aver you call it, the armor on your forearm).

[QUOTE="Creon, post: 231784, member: 2952"] actually i made those myself from scratch out of the oransje PVC Pipes (just asked a local hardwarestoe if they had some leftovers). i first made the bracers then taped some sheets ov paper or cardboard on them to measure the length and add the shape i wanted. then i transfered that pattern on to the PVC pipes and cut them out. finally i heated up the PVC shapes and shaped them to fit the bracers (what aver you call it, the armor on your forearm).;) [/QUOTE]

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification