Reply to thread

Message

Here's a screen cap of my Gauntlet design. I just modelled this as I went, I didn't draw a rough sketch or anything before hand.

[ATTACH]13173[/ATTACH]

I like them, and last night I was thinking about using them for both arms but now I'm not so sure. The cylinders you see are just to represent some sort of launcher tube or barrel. and the block on the outer side of each gaunt will be a mounting bracket of sorts for various weapons. I've not designed those yet.

I was wondering if I might get some opinions as to whether I should use them for both armos or just one? OR even if they just don't fit in with the SW look? That thought has crossed my mind a few times now.

Any feedback is greatly appreciated guys. :

[QUOTE="Skupilkinson, post: 191183, member: 1718"] Here's a screen cap of my Gauntlet design. I just modelled this as I went, I didn't draw a rough sketch or anything before hand. [ATTACH]13173.vB[/ATTACH] I like them, and last night I was thinking about using them for both arms but now I'm not so sure. The cylinders you see are just to represent some sort of launcher tube or barrel. and the block on the outer side of each gaunt will be a mounting bracket of sorts for various weapons. I've not designed those yet. I was wondering if I might get some opinions as to whether I should use them for both armos or just one? OR even if they just don't fit in with the SW look? That thought has crossed my mind a few times now. Any feedback is greatly appreciated guys. : [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification