Reply to thread

With my previous BM bucket I used a small Screw, washer and nut to hold it in place. I did have to bore out the RF stalk just a bit so that the screw would sit flush, I also did the same to the inside of the ear cap to make sure it did not rub against the stalk.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top