Reply to thread

Message

More sanding and building up with Bondo...

I'm taking my time now because I really need a mouse sander.

Basically, all I did was make up three small batches and spread them on the face until it was the thickness I wanted.

Here's the left side...
[ATTACH=full]86236[/ATTACH]
...and here's a close up of the left cheek.
[ATTACH=full]86237[/ATTACH]

I do have some small places to touch up with small bits of filler, and I'm not too worried about the visor area. I can always trim that down later.

If I have time tomorrow, I'll be working on the right side.

David.

[QUOTE="Jaiden, post: 138732, member: 730"] More sanding and building up with Bondo... I'm taking my time now because I [I]really[/I] need a mouse sander. Basically, all I did was make up three small batches and spread them on the face until it was the thickness I wanted. Here's the left side... [ATTACH=full]86236[/ATTACH] ...and here's a close up of the left cheek. [ATTACH=full]86237[/ATTACH] I do have some small places to touch up with small bits of filler, and I'm not too worried about the visor area. I can always trim that down later. If I have time tomorrow, I'll be working on the right side. David. [/QUOTE]

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification