Reply to thread

You have alot of patience.  Using cardboard and then fiberglass resin,  is easier.  I personally used the top of a pro-tec skate helmet.  But im not going for acuracy.  Im doing this whole project as a bet, but have become consumed with it.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top