Reply to thread

Message

I was doing it a few ways because I wasn't 100% sure of what to do. The 1st time I took it off after I was done with the airbrush. That took off lots of paint. The 2nd time I let it dry to the touch. Again, same thing and down to the prymer. Third time I let it dry for 24 hrs, same thing. So I thought I would try a new bottle of latex. 4th time, let it dry for 24 hrs, nope same thing.
5th time I took some fine sandpaper and gently went over the each color but the green. It worked much better but it still took some paint off.

Any ideas?

[QUOTE="Laan, post: 83734, member: 475"] I was doing it a few ways because I wasn't 100% sure of what to do. The 1st time I took it off after I was done with the airbrush. That took off lots of paint. The 2nd time I let it dry to the touch. Again, same thing and down to the prymer. Third time I let it dry for 24 hrs, same thing. So I thought I would try a new bottle of latex. 4th time, let it dry for 24 hrs, nope same thing. 5th time I took some fine sandpaper and gently went over the each color but the green. It worked much better but it still took some paint off. Any ideas? [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification