Reply to thread

Message

Ok, so I'm working on my helmet and I start glueing the triangle stripes for the dome. But something isn't right, the strips aren't going all the way to the middle of the frame. After getting half of the dome finished I realize that I had glued the frame on backwards!!:angry But then I remembered that this is my first attempt so I'm allowed to make some mistakes right? right?

[ATTACH=full]18665[/ATTACH]

[ATTACH=full]18666[/ATTACH]

[ATTACH=full]18667[/ATTACH]

[QUOTE="Lifeburn, post: 264726, member: 3864"] Ok, so I'm working on my helmet and I start glueing the triangle stripes for the dome. But something isn't right, the strips aren't going all the way to the middle of the frame. After getting half of the dome finished I realize that I had glued the frame on backwards!!:angry But then I remembered that this is my first attempt so I'm allowed to make some mistakes right? right? [ATTACH=full]18665[/ATTACH] [ATTACH=full]18666[/ATTACH] [ATTACH=full]18667[/ATTACH] [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification