Reply to thread

Message

Well, I'm molding something that's already been made. So that's going to help keep the cost low because I didn't have to spend any time making a master. Another good thing about Westars is they'll need very little resin to cast. And if I can keep any clean-up on my part down to nil, then that's less I have to charge for my time, unlike gauntlets and/or holsters that include a lot of labor and materials. So I'm hoping to produce these at a very affordable price.

[QUOTE="Cruzer, post: 181945, member: 496"] Well, I'm molding something that's already been made. So that's going to help keep the cost low because I didn't have to spend any time making a master. Another good thing about Westars is they'll need very little resin to cast. And if I can keep any clean-up on my part down to nil, then that's less I have to charge for my time, unlike gauntlets and/or holsters that include a lot of labor and materials. So I'm hoping to produce these at a very affordable price. [/QUOTE]

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification