Reply to thread

Yea, I guess that just makes it easier for you. I guess all you would need to do is take the metal greeblies, lay it flat side down onto some styrene, trace and cut a circle. That's what I'd do


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top