Reply to thread

just wanted to point out something bout the blueprints of the MR flash. most of the visible things on the saber are right but it seems that MR didn't pay too much attention on what was not visible on the saber tube they made. there are a few things wrong with it. just afew examples the largest hole (10mm) on the plans is actually only a 4mm hole. also the distance from the end of the tube to the nameplate rivet hole is about 68mm instead of 65mm there's just more tube on the end. ect. ect.

Seven you got a PM coming yer way :D


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top