Reply to thread

Message

[USER=14665]spicy fett[/USER]
Right on! I meant to also show what the MoW ones look like from the back, for those who haven't seen....
[ATTACH=full]202671[/ATTACH]

Again not a huge deal for me, but I want to get close to screen accurate as possible. And yes, I'm aware that there is a bit too much black on the right hand of my glove. What can I say? My Airbrush suffered a clog and then all of a sudden, started shooting paint out. (#Grrrrrrrr) Not my finest moment, but since I was to be holding an EE-3 during my event it wouldn't have shown anyways. Plus....I'm upgrading these gloves to the Mike M variant. This could potentially wash out too.

Thanks,
-Iron

[QUOTE="Irongladiator, post: 505985, member: 13129"] [USER=14665]spicy fett[/USER] Right on! I meant to also show what the MoW ones look like from the back, for those who haven't seen.... [ATTACH type="full"]202671[/ATTACH] Again not a huge deal for me, but I want to get close to screen accurate as possible. And yes, I'm aware that there is a bit too much black on the right hand of my glove. What can I say? My Airbrush suffered a clog and then all of a sudden, started shooting paint out. ([I]#Grrrrrrrr[/I]) Not my finest moment, but since I was to be holding an EE-3 during my event it wouldn't have shown anyways. Plus....I'm upgrading these gloves to the Mike M variant. This could potentially wash out too. Thanks, -Iron [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification