Reply to thread

Message: <blockquote data-quote="tinstar5541" data-source="post: 244362" data-attributes="member: 2258">I have a set of Wickedbeard  sheet metal gauntlets which use velcro for closures.  The edges overlap each other in order for the velcro to grab.  Would I be able to use these magnets the same way?  I am assuming that I could merely remove all the velcro and attach one magnet to only one side of the clamshell.  It should be powerful enough by itself to grab onto the other part of the clamshell.  Has anyone else out there tried this?p.s.  Fett_MD, I can still see the pics.  The last post was on 4/22 at 7:20 am if that helps.</blockquote>

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification