Reply to thread

Nice... hooked up the 9 volt, flipped the switch on the Zip-Zap controller and got a nice puff of smoke from the Zip-Zap board.  I guess I killed that....


I hooked up the 9 volt to the servo directly... NOTHING.  I guess that's dead too.  I give up... apparently I'm not meant to get this working. :angry


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top