Reply to thread

Message

Best shot I could find for quick reference is attached. It appears the front and rear Molex pairs are pretty close to horizontal alignment with each other (parallel to centerline of the barrel). The difference in size of the front and rear "pipe clamp" parts means the front Molexes are at/near the top of the smaller clamp, while the rear pair is noticeably lower relative to the top of that clamp.

[ATTACH=full]234008[/ATTACH]

[QUOTE="TX30907, post: 528895, member: 15881"] Best shot I could find for quick reference is attached. It appears the front and rear Molex pairs are pretty close to horizontal alignment with each other (parallel to centerline of the barrel). The difference in size of the front and rear "pipe clamp" parts means the front Molexes are at/near the top of the smaller clamp, while the rear pair is noticeably lower relative to the top of that clamp. [ATTACH type="full"]234008[/ATTACH] [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification