Reply to thread

Hmm hadn't thought of that... I was more concerned about making the molds than what to cast them out of, I think mainly because I'd settled on liquid latex (something I keep plenty of around for making LRP-safe swords ... and lightsabers)


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top