Reply to thread

Thanks Stormtrooperguy! That video of yours is exactly what I have been looking for - good show! So a gallon to do a mold huh? Ouch! I am afraid to make an error at that price so I guess I better practice on something smaller. What resin do you use for making the cast?

I guess Boba's lid wouldn't work out too well using a vacuum table? I know the Stormtrooper works out well using that method, but would vacuum forming pick up the details necessary for a good Boba helmet? I am guessing not. Thanks again for the video posts.


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top