Reply to thread

I never heard of industrial vacuum formers using fibreglass moulds?


Wood or metal is the norm afaik.I know they use resins with metal filings or powder,but a fibreglass mould would have to be reinforced big time on an industrial former.


I could be mistaken,but all the pro formers I have spoken to use some kind of metal or alloy mould.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top