MissouriCon 2024

JiM

Hunter
Me dressed as Boba Fett (RotJ version)…
 

Attachments

  • IMG_6161.jpeg
    IMG_6161.jpeg
    2.7 MB · Views: 57
  • IMG_6162.jpeg
    IMG_6162.jpeg
    1.7 MB · Views: 52
Me dressed as Boba Fett (RotJ version)…
Thanks. I think I used the 501st version as a reference and then airbrushed in shades of acrylic burnt umber. I think burnt umber is the most earthish of the earth tones. I also misted it a bit before and after so it would kind of blend and in areas where it was too much or not enough I’d rub it with my fingers.
 
Actually I think it was beige for the pinkish and burnt umber for the browns. My thinking is most of the dirt and grime would be on the lower areas and areas that get touched the most like pocket flaps. I tried to avoid using black but brown just wasn’t dark enough. Use sparingly if you paint your own!
 
This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top