Reply to thread

Message

How does everyone tackle this section on the silver damage layer?

[ATTACH=full]234260[/ATTACH]

On the original, that's where the masking tape was pulled off right? So, I know on TF's thread HERE he leaves it until the end and uses a heavily diluted white to get that faded green colour, however - the fact that it's on the silver damage stencil implies there is silver underneath so, do most people still include it in the silver layer and paint over it at the end?

[QUOTE="Short4ATrooper, post: 529126, member: 16204"] How does everyone tackle this section on the silver damage layer? [ATTACH type="full"]234260[/ATTACH] On the original, that's where the masking tape was pulled off right? So, I know on TF's thread [URL='https://www.thedentedhelmet.com/forums/threads/one-last-wafer-thin-esb-paint-job.12360/']HERE[/URL] he leaves it until the end and uses a heavily diluted white to get that faded green colour, however - the fact that it's on the silver damage stencil implies there is silver underneath so, do most people still include it in the silver layer and paint over it at the end? [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification