Reply to thread

Thank you. I literally had a brainwave a millisecond after posting and realised I could just put holes in the helmet to secure the faceplate screws from inside the helmet so that’s what I did.


I wanted to get everything on before I tackle the weathering so I can do it as one piece and keep it consistent. I’ll have to take the right ear apart down the line as I’ve got a wireless servo kit on order.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top