Reply to thread

Hey,

 

I'm yet to update the website.  It should be up in the next day or two.

 

 

The plates are held onto the boots in this picture with some double sided tape, but only for the picture,  The actual spikes are going to be held onto the boots via screws.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top