Reply to thread

So today I used my dremel and a bunch of files to cut out the safety slot in the trigger guard. The trigger actually fell apart as I was cleaning around it, so I just hacked it off altogether. I'll rebuild it with JB Weld or something and just glue it back on. It actually worked out well because the slot was easier to make without the trigger in the way.


[ATTACH=full]127851[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top