Reply to thread

Message

Going to start work on the holster I got from Kcr7pr. This is going to need a lot of smoothing and filling. A lot.

[ATTACH=full]127817[/ATTACH]

[ATTACH=full]127818[/ATTACH]

I would like to cut the knife pocket off, but because of the way these are molded it's impossible. You would end up with just a big whole in the front of the holster. Not a big deal, just would have been cool to cut it off.

[QUOTE="Matty Matt, post: 348890, member: 1179"] Going to start work on the holster I got from Kcr7pr. This is going to need a lot of smoothing and filling. A lot. [ATTACH=full]127817[/ATTACH] [ATTACH=full]127818[/ATTACH] I would like to cut the knife pocket off, but because of the way these are molded it's impossible. You would end up with just a big whole in the front of the holster. Not a big deal, just would have been cool to cut it off. [/QUOTE]

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification