Reply to thread

Finally had a bit of time this weekend to take the dremel to the armor and start trimming. Quickly realized I was not going to be able to blow through them so decided to take my time. I finished trimming the knee armor sans drilling out the dart holes, going to work on them first. And did a rough job on the back armor. Going to finish the back armor coming up this weekend. Drying to get straight  lines on the plastic with a dremel was difficult so I ended up doing some final straightening and polishing with some sandpaper. Seems to have worked nicely. More to come this weekend.


[ATTACH=full]198608[/ATTACH]

[ATTACH=full]198609[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top