Back in AZ and decided to get back on this thing, sort of. I have the visor in hand and I'm going to have to figure out what I'm gonna do.
The visor I got curtousey of Sean, and it's amazing to have a well produced and accurate visor!
Now onto it. The only thing about the visor is that it's not gonna be 100% flush if I were to install it right away. There is some gaps between it and the helmet. I've managed to get it pretty close, but still a gap. I'm considering doing what sean did to his helmets and bondo/fill the gaps and re-touch up the paint. The only thing is that I need to hold alot of preasure on the visor to get it to sit where I need it to.
So anyways, Here's me holding the visor in place. Gotta be careful thought, the mirrachrome is painted on the inside, and fingerprints can take it off the acrylic!!
[ATTACH=full]119723[/ATTACH]
[ATTACH=full]119724[/ATTACH]
I also decided to do a small detail I think looks pretty good; I went out and got some car door rubber trimming to add to the inner edge of the helmet. I didn't get the sides that slant up only because the rubber would have looked kinda "off" and wouldn't bend the way I'd like it to, but I'm happy with it
[ATTACH=full]119725[/ATTACH]
Oh yea, and here's that "liner." I mean, I can use it, but I need to add foam underneath it and foam all around it. I really was expecting to get the whole sha-bang, but eh...
[ATTACH=full]119726[/ATTACH]
Stay tuned...
-TC
