Reply to thread

I've been doing a method where I place a small blob in a more open area and use the very tip of the rubber brush to just break the surface of the blob and then pull it into the smaller lines.  Very small thin scratches you can use toothpicks, straightened staples, calligraphy nibs, atoms or anything else small and thin you can find.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top