Reply to thread

This copy was made from high impact casting resin.  Not cheap stuff, this is the high end stuff.  The copies will most likely be skinned in this stuff and FG inside.  This is the way I did all of my MS3's  It makes for a clean and strong surface.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top