Reply to thread

Message

As far as hands go, not sure where I saw this but some one cut off the fingers applied some bind able wire with bondo and then covered the wire with the same type of hose that is used for the gauntlets over the wire and cut it to size. From the pic's I saw it looked like it worked pretty well. This is what I plan to do to mine now that I'm almost done with my blaster (hasbro mod) I would say just do a search on the net u might be able to find an easy way of doing this.

Chris

[QUOTE="Army, post: 346192, member: 4369"] As far as hands go, not sure where I saw this but some one cut off the fingers applied some bind able wire with bondo and then covered the wire with the same type of hose that is used for the gauntlets over the wire and cut it to size. From the pic's I saw it looked like it worked pretty well. This is what I plan to do to mine now that I'm almost done with my blaster (hasbro mod) I would say just do a search on the net u might be able to find an easy way of doing this. Chris [/QUOTE]

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification