Reply to thread

Good luck on your project then.:) Let us know how it turns out. If silicone will cure properly in a water based mold, is of extreme interest to me, as well.

 

One thing you may want to consider instead of wire for the inside, though, is 1/4" copper tubing. It will bend better, and it's diameter will give you better displacement inside the rubber.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top