Reply to thread

Message

Hello, newbie here!

Currently, I am planning to work on a bucket based on GreatApeStudio's file and I'm currently stuck on a conundrum. That is: does the vents at the back of Mando's helmet have holes drilled in?

So there's this reference pic of Mando's helmet vent that I have attached, and I can't tell if it has holes or not. I know the Anovos and efx ones have black painted on the 'holes' to act as a fake shadow. I'm asking because GreatApe's file has holes on them and I'm a sucker for accuracy haha. Any help is appreciated.

Thanks!

Actual helmet reference:
[ATTACH=full]220094[/ATTACH]

Great ape's model:
[ATTACH=full]220095[/ATTACH]

[QUOTE="Vassau, post: 520730, member: 16395"] Hello, newbie here! Currently, I am planning to work on a bucket based on GreatApeStudio's file and I'm currently stuck on a conundrum. That is: does the vents at the back of Mando's helmet have holes drilled in? So there's this reference pic of Mando's helmet vent that I have attached, and I can't tell if it has holes or not. I know the Anovos and efx ones have black painted on the 'holes' to act as a fake shadow. I'm asking because GreatApe's file has holes on them and I'm a sucker for accuracy haha. Any help is appreciated. Thanks! Actual helmet reference: [ATTACH type="full" width="563px"]220094[/ATTACH] Great ape's model: [ATTACH type="full" width="462px"]220095[/ATTACH] [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification