Reply to thread

Message

I'm 3d printing my helmet now, should be done this week. Next step is to identify the proper paint color and brand of paint to use.

I do have a full set of air brushing gear but have never taken the time to learn how to use it. If I can find a rattle can that is a good match on color I'll keep it simple and go that route.

These 3 cans came from the local Menards. The metallic paint is about double the cost of the standard stuff. I will spray on some test coats tonight and tomorrow and get some screenshots up for people to see the differences.

[ATTACH=full]185046[/ATTACH]

[QUOTE="Mandotog, post: 490153, member: 13214"] I'm 3d printing my helmet now, should be done this week. Next step is to identify the proper paint color and brand of paint to use. I do have a full set of air brushing gear but have never taken the time to learn how to use it. If I can find a rattle can that is a good match on color I'll keep it simple and go that route. These 3 cans came from the local Menards. The metallic paint is about double the cost of the standard stuff. I will spray on some test coats tonight and tomorrow and get some screenshots up for people to see the differences. [ATTACH type="full"]185046[/ATTACH] [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification