Reply to thread

I 3D printed the handle from this file:  The Mandalorian Knife by TonyBloke from TonyBloke.  I made my own blade from EVA foam to attach to it in case I ever pulled it out it wouldn't have any rigidity to cause anyone any harm.  This handle looks spot on and looked great when i painted and weathered it.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top