Reply to thread

Yeah the mold will need to be looked at a bit. Unfortunately there was a couple of bubbles in the silicone that i tried to patch up and it makes the molds a little rough looking. I would be looking to sand and properly prepare any molds i sold if i ever do. I amy also have to slighlty redo the longer ear a bit as it seems a little short when i compare it to my helmet that im building. The inner rangefinder top though is coming out not to shabby with the mold lines so im happy with that bit of the design.

The original prototype had me wrapping the wire to a solid metal ar and then encasing it in the stock but i have since found a hollow rod that is small enough to be encased in the resin and also allow the wires to slip though.

As i sort of hinted at this is just me starting out so any feed back is appreciated.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top