Reply to thread

Applied more bondo to outside of helmet, smoothing out defects, and sanded like crazy.

Applied black gloss primer to helmet, still have some areas that need to be smoothed out, and more sanding prior to applying the chrome paint

Also working on the inside portion of the helmet which I applied a ledge that will meet the liner, and primed the inside of the helmet.

With all the chemicals used in making the helmet, i.e. Bondo, resin, paint, glue etc. I found a great material to use for the lining that can seal off the helmet from the wearer. The material was found at the local Walmart,  Pro-Tuff Outdoor Solid Fabric, it's durable, polyester-faced material and has a PVC backing, waterproof and easy to clean.

I'll be applying it next week.

[ATTACH=full]188525[/ATTACH][ATTACH=full]188526[/ATTACH][ATTACH=full]188527[/ATTACH][ATTACH=full]188528[/ATTACH][ATTACH=full]188529[/ATTACH][ATTACH=full]188530[/ATTACH][ATTACH=full]188531[/ATTACH][ATTACH=full]188532[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top