Reply to thread

Message

Went out earlier and cut a 1 foot by 1 foot sheet of Gray 1/8 Plastic I bought from US Plastics.com down into the proper shape. Clamped it to the table and used my heat gun to bend the plastic. I will be heading to the store to pick up some of those Chicago screws, epoxy, and washers I been reading about. Here is what I have so far.

One thing I still need to do is to build up the center of the helmet to give it a higher arc, to get it more in line with the Mandalore the Preserver helmet seen in KOTOR 2. Any ideas or techniques that might be easier to do then layering bondo?

[ATTACH=full]31246[/ATTACH]

[ATTACH=full]31247[/ATTACH]

[QUOTE="CyraxLionheart, post: 338013, member: 5743"] Went out earlier and cut a 1 foot by 1 foot sheet of Gray 1/8 Plastic I bought from US Plastics.com down into the proper shape. Clamped it to the table and used my heat gun to bend the plastic. I will be heading to the store to pick up some of those Chicago screws, epoxy, and washers I been reading about. Here is what I have so far. One thing I still need to do is to build up the center of the helmet to give it a higher arc, to get it more in line with the Mandalore the Preserver helmet seen in KOTOR 2. Any ideas or techniques that might be easier to do then layering bondo? [ATTACH=full]31246[/ATTACH] [ATTACH=full]31247[/ATTACH] [/QUOTE]

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification