Reply to thread

Message

I've recently just started on my Boba Fett project, beginning with the armor plates, and wondered how to add the slots in the chest armor for the led display, before I begin on the paint job. I'm not quite sure how to do this properly, and I'm kind of scared I'll damage it. (I accidentally made a crack in my Stormtrooper helmet before while assembling it, thankfully that was underneath the ear-pieces and thus fixable.)
Anyone have any methods and/or tips?
The plates are just the plastic(sintra) kind, not resin.

[QUOTE="Booky, post: 310248, member: 5008"] I've recently just started on my Boba Fett project, beginning with the armor plates, and wondered how to add the slots in the chest armor for the led display, before I begin on the paint job. I'm not quite sure how to do this properly, and I'm kind of scared I'll damage it. (I accidentally made a crack in my Stormtrooper helmet before while assembling it, thankfully that was underneath the ear-pieces and thus fixable.) Anyone have any methods and/or tips? The plates are just the plastic(sintra) kind, not resin. [/QUOTE]

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification