Reply to thread

Message

Thanks!

Today I did the first steps for a complete helmet. I have redone the rear keyhole and the back panel paint and scratches templates and glued on to the helmet.

[ATTACH]35041[/ATTACH] [ATTACH]35044[/ATTACH] [ATTACH]35043[/ATTACH] [ATTACH]35042[/ATTACH] [ATTACH]35040[/ATTACH] [ATTACH]35039[/ATTACH] [ATTACH]35045[/ATTACH]

And here is the helmet with the MQ-1 circuit board instaled. I made the circuit board with minimal effort. I did just 4 pieces and covered with colored paper.

[ATTACH]35047[/ATTACH] [ATTACH]35046[/ATTACH]

I have to do each part with care, because before I glue on the templates I must glue on each paint and scratches template too, this way I will cover every surface of the helmet. The next step will be the hardest of all: THE DOME. This has to be as perfect as possible and not to mention the paint templates for the dome...

Respect!

<blockquote data-quote="RafalFett" data-source="post: 320264" data-attributes="member: 4963">Thanks!Today I did the first steps for a complete helmet. I have redone the rear keyhole and the back panel paint and scratches templates and glued on to the helmet.[ATTACH]35041[/ATTACH] [ATTACH]35044[/ATTACH] [ATTACH]35043[/ATTACH] [ATTACH]35042[/ATTACH] [ATTACH]35040[/ATTACH] [ATTACH]35039[/ATTACH] [ATTACH]35045[/ATTACH]And here is the helmet with the MQ-1 circuit board instaled. I made the circuit board with minimal effort. I did just 4 pieces and covered with colored paper.[ATTACH]35047[/ATTACH] [ATTACH]35046[/ATTACH]I have to do each part with care, because before I glue on the templates I must glue on each paint and scratches template too, this way I will cover every surface of the helmet. The next step will be the hardest of all: THE DOME. This has to be as perfect as possible and not to mention the paint templates for the dome...Respect!</blockquote>

[QUOTE="RafalFett, post: 320264, member: 4963"] Thanks! Today I did the first steps for a complete helmet. I have redone the rear keyhole and the back panel paint and scratches templates and glued on to the helmet. [ATTACH]35041.vB[/ATTACH] [ATTACH]35044.vB[/ATTACH] [ATTACH]35043.vB[/ATTACH] [ATTACH]35042.vB[/ATTACH] [ATTACH]35040.vB[/ATTACH] [ATTACH]35039.vB[/ATTACH] [ATTACH]35045.vB[/ATTACH] And here is the helmet with the MQ-1 circuit board instaled. I made the circuit board with minimal effort. I did just 4 pieces and covered with colored paper. [ATTACH]35047.vB[/ATTACH] [ATTACH]35046.vB[/ATTACH] I have to do each part with care, because before I glue on the templates I must glue on each paint and scratches template too, this way I will cover every surface of the helmet. The next step will be the hardest of all: THE DOME. This has to be as perfect as possible and not to mention the paint templates for the dome... Respect! [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification