Reply to thread

In an effort to make our Zam V2 even better I have begun making the gauntlets:







It's a little crude so my plan is to mold this, make a casting and clean up, sand, and fine tune the casting then make another mold .. actually 2 more molds because I need one for each half so it can hinge open like the original.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top