Reply to thread

I was wondering if you can make a mold out of liqurd latex? Trying to make a mold of small clay sculpture so i can make a hard copy out of resin and was wondering how to do it? I hear it can be done but after a while the latex loses detail and the copies become smaller. But was wondering if anyone has tip and what not.


Thanks for your time


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top