Reply to thread

Message

Part 2

I bought a bunch of cheap fabric to mess around with. I traced around the template (four pieces for two spats), and then cut roughly around the pieces.

Next, I pinned two pieces together, then cut more closely around the line, probably 3/8".

I stitched along the outer/bottom edge of the piece, as shown in the pics.

[ATTACH=full]7690[/ATTACH]

[ATTACH=full]7691[/ATTACH]

[ATTACH=full]7692[/ATTACH]

[QUOTE="Rich D, post: 114576, member: 1047"] [b]Part 2[/b] I bought a bunch of cheap fabric to mess around with. I traced around the template (four pieces for two spats), and then cut roughly around the pieces. Next, I pinned two pieces together, then cut more closely around the line, probably 3/8". I stitched along the outer/bottom edge of the piece, as shown in the pics. [ATTACH=full]7690[/ATTACH] [ATTACH=full]7691[/ATTACH] [ATTACH=full]7692[/ATTACH] [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification