Reply to thread

Message

icedevil

hi

i done exactly the same as you. i made my bucket from card etc and then after coating in vaseline i covered the whole thing plaster cast bandages. i then had to cut the whole thing in two to be left with the two cast moulds. i then cast mine in resin mortor so i had something more rigid to work on (see 'my unfinished project' in the helmet forum).

i plan to now repeat the process but with fibreglass.

[QUOTE="Ronin677, post: 57531, member: 998"] icedevil hi i done exactly the same as you. i made my bucket from card etc and then after coating in vaseline i covered the whole thing plaster cast bandages. i then had to cut the whole thing in two to be left with the two cast moulds. i then cast mine in resin mortor so i had something more rigid to work on (see 'my unfinished project' in the helmet forum). i plan to now repeat the process but with fibreglass. [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification