Reply to thread

[USER=11832]Loufett[/USER]

Your work is looking really good. I also experienced that crinkling effect too - on my helmet. I sealed mine up with Rustoleum's Matte Clear Enamel. What I recalled my issue was being too close to the helmet (not following the instructions in being 10-12 inches away from the helmet). I've used this sealer before too with no issue., And I still use it, cause it is good stuff, but now I misted it on over a few sessions and staying 10-12 inches away and not a problem since. But I feel ya - sucks when that happens. But keep up the great work.

:cool:(y)


Best,

-Iron


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top