Reply to thread

Message

^ ^ exactly FD.

The back mount is about 1/4 to 1/2 inch higher up. due to the barrell change in size.

The mounts are both roughly the same size at the top. Which means ones a squatty A and ones a tall A. The talls in the front.

The 'shroud' looks like it acts as a rail for the scope mount. Theres a screw that stops the 'shroud' from being on top of the rail. Theres not room. Which means it IS the rail.

The rail, has enough room for the scope bracket to pinch under it, But its not raised up on a giant block like in the diagrams.

Now, regardless, two things catch my eye on arts picture.

Theres a diaganol line, and no horizontal line, leaving the top of the molex. Heading towards the top of the mount. And at the bottom of the molex, you see another angled piec cutting in towards the clamp.

<blockquote data-quote="Stormrider" data-source="post: 201279" data-attributes="member: 2155">^ ^ exactly FD.The back mount is about 1/4 to 1/2 inch higher up.&nbsp; due to the barrell change in size.&nbsp; The mounts are both roughly the same size at the top.&nbsp; Which means ones a squatty A and ones a tall A.&nbsp; The talls in the front.The &#039;shroud&#039; looks like it acts as a rail for the scope mount.&nbsp; Theres a screw that stops the &#039;shroud&#039; from being on top of the rail.&nbsp; Theres not room.&nbsp; Which means it IS the rail.The rail,&nbsp; has enough room for the scope bracket to pinch under it,&nbsp; But its not raised up on a giant block like in the diagrams.Now,&nbsp; regardless, two things catch my eye on arts picture.Theres a diaganol line, and no horizontal line,&nbsp; leaving the top of the molex.&nbsp; Heading towards the top of the mount.&nbsp; And at the bottom of the molex, you see another angled piec cutting in towards the clamp.</blockquote>

[QUOTE="Stormrider, post: 201279, member: 2155"] ^ ^ exactly FD. The back mount is about 1/4 to 1/2 inch higher up. due to the barrell change in size. The mounts are both roughly the same size at the top. Which means ones a squatty A and ones a tall A. The talls in the front. The 'shroud' looks like it acts as a rail for the scope mount. Theres a screw that stops the 'shroud' from being on top of the rail. Theres not room. Which means it IS the rail. The rail, has enough room for the scope bracket to pinch under it, But its not raised up on a giant block like in the diagrams. Now, regardless, two things catch my eye on arts picture. Theres a diaganol line, and no horizontal line, leaving the top of the molex. Heading towards the top of the mount. And at the bottom of the molex, you see another angled piec cutting in towards the clamp. [/QUOTE]

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification