Reply to thread

That's looking pretty darned good so far Storm. Here are a few constructive points as I see: The top C-shaped "sash" should be a tiny bit thicker, and a wee bit more squared off. Also it has two holes through the front (and I assume) rear faces. The center "spine" should be thinner, and not tube shaped. Just some observations. Darned fine work bro!


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top