Reply to thread

If you have the Cad files for that plate it would be greatly appreciated.  I have just cut out some rough ones about 30 minutes ago, and plan to put them on tonight.  It woul dbe nice to have the correct size though.


Once again though buddy, thanks for your templates.  All i did was 'bolt' everything together, i my opinion you did the hard work :cheers


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top