Reply to thread

Message

Thanks for the kind words mate, I really hope I can make some progress soon. It's been sitting around for a while!

One thing I did notice though, I was looking at BM's pack on his site and noticed that the central column on his JP is the same width as the housing for the rocket. On yours it does look as if the central column is not as wide as the housing.

Perhaps you could add some filler to make these match up?

[QUOTE="mandalore697, post: 92544, member: 594"] Thanks for the kind words mate, I really hope I can make some progress soon. It's been sitting around for a while! One thing I did notice though, I was looking at BM's pack on his site and noticed that the central column on his JP is the same width as the housing for the rocket. On yours it does look as if the central column is not as wide as the housing. Perhaps you could add some filler to make these match up? [/QUOTE]

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification